Aftermarket · Vehicle-specific
EG1Z-19G490

EG1Z-19G490 Ford Taurus factory rearview camera (2013-2019)

Key features

  • [It can be used as soon as the OE is matched] OE: EG1Z-19G490 | Model: Ford Taurus 2013-2019 (2.0L EcoBoost / 3.5L V6, SE / SEL / Limited / SHO) | Location: Rear view reversing camera. Please provide the customer with factory camera photos for verification again
  • Ford Taurus factory rearview camera, OE EG1Z-19G490, 2013-2019
  • The catalog contains a fit list (fit car model.txt) organized by model year/engine/configuration, which can be checked item by item
  • Common specifications for US series: 1/4" CMOS active pixel array, Nidec (Japan) glass + plastic lens
  • Minimum illumination 0.1Lux, effective pixels 728×582, 600 TV lines
  • Viewing angle 170°, standard NTSC / PAL, electronic shutter 1/50~1/100,000 seconds
  • Waterproof to IP68, power supply DC 6~12V
  • The factory harness plug is connected, no wire cutting, the appearance is matches the factory part

Ordering notes

Points to confirm before production so the unit arrives ready to fit.

  • Ask the customer for photos of the factory camera — front, back, plug, bracket and the OE label on the housing — and check them against ours one by one.
  • Check that the OE number EG1Z-19G490 is completely consistent (there is another line in the OE cross-reference list EG1Z-19G490 Taurus 2015-2019, pay attention to the year and caliber)
  • Use fit car model.txt in the catalog to check the year, engine and configuration (2.0T / 3.5L, AWD / FWD, SE / SEL / Limited / SHO)
  • Confirm the camera position — reversing view, or which channel of the 360 system.
  • Confirm quantity, packaging and printing.

Installation & usage

Voltage, wiring, sealing and maintenance guidance for the installer.

  • Disconnect the battery negative terminal before installation and keep the circuit unpowered while working.
  • When removing original parts, protect the clips, seals and plugs — do not force them.
  • After fitting, check the clips are fully seated and the seal is compressed so water cannot seep in.
  • Power on and test whether the rear view image and the factory dynamic auxiliary line are normal
  • When washing, do not hold a pressure washer directly on the camera or connector.
  • Keep the original parts you removed.
OEM Replacement Cameras

Other models in this range

See all 31 products in this range

Need a quotation for the EG1Z-19G490?

Send us the quantity, the vehicle or application, and the destination market. We will confirm the specification and quote within 24 hours.

Email Us for a Quote
Emailinfo@jfacam.com
WhatsApp+86 188 7400 7838
Tel+86-0755-2819 2146