JPC-38 new integrated bracket car camera (integrated bracket / CVBS 110°)

Key features

New integrated bracket design: camera and bracket as one compact unit
Fastest fitting of the range: no hole saw needed, screw the bracket on and aim the lens
Sensor 1/4" PC7440; format NTSC / PAL optional
648(H) x 488(V) pixels; horizontal view angle 110 degree
Lens 1G3P + IR spherical lens set, focal length 1.88mm, distortion -0.23
Minimum illumination 0.1LUX; sensitivity 13.2 V/Lux.sec
Auto shutter, auto exposure brightness, auto white balance
Signal-to-noise ratio 60dB; CVBS video output; frame rate NTSC 60fps / PAL 50fps
Operating voltage DC12V; body material plastic
Waterproof level IP67; interface type RCA
Operating temperature -20°C to +70°C, storage -30°C to +80°C
Universal for all cars; rear, front or side mounting

Points to confirm before production so the unit arrives ready to fit.

Confirm whether the fixing hole position and angle range of the integrated bracket match the vehicle model
Confirm the signal type: This model is CVBS; if you need AHD720P / 1080P, please choose another model
Confirm the chip solution (CVBS optional: 1058 / 4089 / 7430 / 7440 / 7080; this model is marked PC7440)
Confirm the lens angle: this model is 110° horizontally; if you need 135° / 150° / 170°, please inform us in advance
Confirm PAL or NTSC, whether parking guide lines are needed, and normal or mirrored image.
Confirm connector: RCA (standard), whether it needs to be changed to 4-pin aviation connector/BMW connector
Confirm voltage 12V / 24V and cable length
Confirm the waterproof level requirements (this model is IP67, please indicate if you require IP69K)
Confirm color, accessories (screws) and packaging, silk screen requirements

Voltage, wiring, sealing and maintenance guidance for the installer.

Confirm the voltage before wiring (DC12V; 24V models need to choose the 24V version). Do not connect the red and black power cords reversely
Before installing the integrated bracket, clean the fixing surface, tighten the screws and confirm that the angle will not change again
This model is a CVBS output and must be equipped with a CVBS host; pictures cannot be output when connected to an AHD host
Route the cable clear of hot surfaces and sharp sheet-metal edges, and do not pull the tail cable tight.
The connector (RCA) should be waterproof, the bumper position is easy to be washed away by water
Clean the lens with a soft cloth — never alcohol or anything abrasive.
Pay attention to check whether the bracket screws are loose when used outdoors for a long time

Car & Aftermarket Cameras