JPC-05LED snap-in car camera with light (snap-in + LED fill light)

Key features

Flush mount (snap-in) reversing camera with built-in LED illumination
LED lamps light up the ground behind the car - much clearer picture at night
Neat installed look: the camera sits almost flush with the bumper
Universal fitting for all cars; rear, front or side mounting
Signal options: CVBS 420/480 TV Lines, AHD 720P, AHD 1080P
Sensor options: HD CCD / CMOS; star-light night vision module (GC2053 / GC2083)
PAL or NTSC signal system; mirror image and reversing grid selectable
Waterproof IP69K housing with sealed lens ring
DC 12V standard, 24V optional; circuit protection function
Adjustable camera angle
Package: 1 x camera, 1 x 1 m DC power cable, 1 x 6 m AV cable, 1 x hole saw
Standard tail cable 5 copper + 5 steel; optional non-heating switch board tail cable and single / dual / triple LED control

Points to confirm before production so the unit arrives ready to fit.

Confirm the cut-out size (18.5 mm, 28 mm and others) matches the vehicle.
Confirm the signal type: CVBS, AHD 720P or AHD 1080P. An AHD camera must be paired with an AHD host.
Confirm the chipset — CVBS: 1058 / 4089 / 7430 / 7440 / 7080; AHD: 2053 / 528 / 536D / 536 / 4109.
Confirm lens angle. Around 108° horizontal is standard (110° nominal); 135° / 150° / 170° wide-angle versions are optional.
Confirm LED count and control method (always on, reverse-triggered or switch panel), and whether a low-heat switch-panel tail cable is required.
Confirm the system PAL / NTSC, whether the reverse scale line, front image / mirror image is required
Confirm the connector: RCA, 4-pin aviation or BMW type.
Confirm 12V or 24V, plus tail cable construction and length.
Confirm colour, accessories, packaging type and printing.

Voltage, wiring, sealing and maintenance guidance for the installer.

Before wiring, confirm the supply — DC 12V, or the 24V version on a 24V vehicle — and never reverse the red and black supply wires.
Confirm the hole diameter and panel thickness before cutting; on a push-in camera make sure the seal is compressed so no water gets in.
The LED light panel is a thin plate structure. Do not squeeze or bump it during installation
Route the cable clear of hot surfaces and sharp sheet-metal edges, and do not pull the tail cable tight.
Seal the connector properly; bumper positions take a lot of water spray.
Clean the lens and LED board with a soft cloth — never alcohol or anything abrasive.
AHD cameras must be paired with an AHD host; CVBS and AHD cannot be mixed.

Car & Aftermarket Cameras