JPC-06 Square external car camera (supply model JPC-15 / surface mounting without opening holes)

Key features

Supplier model JPC-15; square bolt-on (plug-in) reversing camera
Surface mount design: screws on to the bumper, garnish or licence area - no big hole needed
Easy retrofit: suits cars where drilling a 18.5 / 28mm hole is not wanted
Universal fitting for all cars; rear, front or side mounting
Signal options: CVBS 420/480 TV Lines, AHD 720P, AHD 1080P
Sensor options: HD CCD / CMOS; star-light night vision module (GC2053 / GC2083)
PAL or NTSC signal system; mirror image and reversing grid selectable
Waterproof IP69K housing with sealed lens ring
DC 12V standard, 24V optional; circuit protection function
Adjustable camera angle
Package: 1 x camera, 1 x 1 m DC power cable, 1 x 6 m AV cable
Standard tail cable 5 copper + 5 steel; BMW plug and pure-copper cable optional

Points to confirm before production so the unit arrives ready to fit.

Confirm the installation method: plug-in type (no need to open large holes) or need to be changed to the open-hole version
Confirm whether the shell size and fixing hole position match the bumper/trim of the vehicle model
Confirm the signal type: CVBS, AHD 720P or AHD 1080P. An AHD camera must be paired with an AHD host.
Confirm the chipset — CVBS: 1058 / 4089 / 7430 / 7440 / 7080; AHD: 2053 / 528 / 536D / 536 / 4109.
Confirm lens angle. Around 108° horizontal is standard (110° nominal); 135° / 150° / 170° wide-angle versions are optional.
Confirm whether LED illumination and a switch-panel tail cable are required.
Confirm PAL or NTSC, whether parking guide lines are needed, and normal or mirrored image.
Confirm the connector (RCA, 4-pin aviation or BMW type) and voltage 12V / 24V.
Confirm color, accessories (screws), packaging form and silk screen

Voltage, wiring, sealing and maintenance guidance for the installer.

Before wiring, confirm the supply — DC 12V, or the 24V version on a 24V vehicle — and never reverse the red and black supply wires.
Before installing the plug-in, clean the pasting/fixing surface, tighten the screws and seal them well
Route the cable clear of hot surfaces and sharp sheet-metal edges, and do not pull the tail cable tight.
Seal the connector properly; bumper positions take a lot of water spray.
Tighten the screws once the angle is set, so vibration cannot shift the lens.
Clean the lens with a soft cloth — never alcohol or anything abrasive.
AHD cameras must be paired with an AHD host; CVBS and AHD cannot be mixed.

Car & Aftermarket Cameras