JPC-30 square dome snap-in car camera (square dome shell)

Key features

Square cap (square dome) flush mount camera - a squarer version of the classic small dome
Flush mounted: the lens sits almost level with the bumper for a tidy look
Square front face covers the hole edges neatly
Universal for all cars; rear, front or side mounting
Signal options: CVBS 420/480 TV Lines, AHD 720P, AHD 1080P
Sensor options: HD CCD / CMOS; star-light night vision module (GC2053 / GC2083)
PAL or NTSC signal system; mirror image and reversing grid selectable
Waterproof IP69K housing with sealed lens ring
DC 12V standard, 24V optional; circuit protection function
Package: 1 x camera, 1 x 1 m DC power cable, 1 x 6 m AV cable, 1 x hole saw
Standard tail cable 5 copper + 5 steel; BMW plug and pure-copper cable optional

Points to confirm before production so the unit arrives ready to fit.

Confirm whether the opening size (common 18.5mm / 28mm) and square frame size match the model
Confirm the signal type: CVBS, AHD 720P or AHD 1080P. An AHD camera must be paired with an AHD host.
Confirm the chipset — CVBS: 1058 / 4089 / 7430 / 7440 / 7080; AHD: 2053 / 528 / 536D / 536 / 4109.
Confirm lens angle. Around 108° horizontal is standard (110° nominal); 135° / 150° / 170° wide-angle versions are optional.
Confirm whether LED illumination and a switch-panel tail cable are required.
Confirm PAL or NTSC, whether parking guide lines are needed, and normal or mirrored image.
Confirm connector and voltage 12V / 24V.
Confirm tail cable construction — 5 copper / 5 steel is standard — and whether pure copper, an extension and a custom length are needed.
Confirm colour, accessories (hole saw), packaging and printing requirements.

Voltage, wiring, sealing and maintenance guidance for the installer.

Before wiring, confirm the supply — DC 12V, or the 24V version on a 24V vehicle — and never reverse the red and black supply wires.
Before opening the hole, confirm the hole diameter and sheet metal thickness; after snapping in, the sealing ring must be pressed tightly to prevent water leakage
After the square outer frame is installed, check whether the surroundings fit well with the sheet metal to avoid water ingress in the gaps
Route the cable clear of hot surfaces and sharp sheet-metal edges, and do not pull the tail cable tight.
Seal the connector properly; bumper positions take a lot of water spray.
Clean the lens with a soft cloth — never alcohol or anything abrasive.
AHD cameras must be paired with an AHD host; CVBS and AHD cannot be mixed.

Car & Aftermarket Cameras