JPC-28 metal universal square head car camera (supply model LH-151 / full metal housing)

Key features

Supplier model LH-151; universal square camera with a full metal housing
Metal shell: stronger, better heat dissipation and more premium look than plastic
Suitable for trucks, vans and vehicles working in rough conditions
Universal for all cars; rear, front or side mounting
Signal options: CVBS 420/480 TV Lines, AHD 720P, AHD 1080P
Sensor options: HD CCD / CMOS; star-light night vision module (GC2053 1/2.9" or GC2083 1/3")
Star-light night vision module: coaxial AHD1080P / 720P / CVBS output, 3D-DNR / 2D-DNR, 0.001Lux@(F1.2,AGC ON)
PAL or NTSC signal system; mirror image and reversing grid selectable
Waterproof IP69K housing with sealed lens ring
DC 12V standard, 24V optional; circuit protection function
Adjustable camera angle
Package: 1 x camera, 1 x 1 m DC power cable, 1 x 6 m AV cable, 1 x hole saw
Standard tail cable 5 copper + 5 steel; BMW plug and pure-copper cable optional

Points to confirm before production so the unit arrives ready to fit.

Confirm whether the shell size and opening size match the vehicle model
Confirm surface treatment (black spray/silver anodized) and color requirements
Confirm the signal type: CVBS, AHD 720P or AHD 1080P. An AHD camera must be paired with an AHD host.
Confirm the chipset — CVBS: 1058 / 4089 / 7430 / 7440 / 7080; AHD: 2053 / 528 / 536D / 536 / 4109.
Confirm lens angle. Around 108° horizontal is standard (110° nominal); 135° / 150° / 170° wide-angle versions are optional.
Confirm whether LED illumination and a switch-panel tail cable are required.
Confirm PAL or NTSC, whether parking guide lines are needed, and normal or mirrored image.
Confirm connector and voltage 12V / 24V, plus tail cable construction and length.
Confirm accessories (hole opener/screws) and packaging and silk screen requirements

Voltage, wiring, sealing and maintenance guidance for the installer.

Before wiring, confirm the supply — DC 12V, or the 24V version on a 24V vehicle — and never reverse the red and black supply wires.
The metal housing is heavier, so the fixing screws must be tightened and anti-loosening washers must be added if necessary
Pay attention to insulation/anti-rust treatment between the metal housing and the car body to avoid long-term contact corrosion
Route the cable clear of hot surfaces and sharp sheet-metal edges, and do not pull the tail cable tight.
Seal the connector properly; bumper positions take a lot of water spray.
Clean the lens and housing with a soft cloth, do not wipe with alcohol or hard objects
AHD cameras must be paired with an AHD host; CVBS and AHD cannot be mixed.

Car & Aftermarket Cameras