JPC-26 Square plug-in car camera with a circle of lights (square plug-in + ring LED fill light)

Key features

Square bolt-on (plug-in) camera with a full ring of LED lamps around the lens
LED ring gives a bright, even light behind the car - best night picture in the square family
Surface mount: screws on to bumper / garnish, no big hole needed
Square front face with a tidy, near-flush look
Universal for all cars; rear, front or side mounting
Signal options: CVBS 420/480 TV Lines, AHD 720P, AHD 1080P
Sensor options: HD CCD / CMOS; star-light night vision module (GC2053 / GC2083)
PAL or NTSC signal system; mirror image and reversing grid selectable
Waterproof IP69K housing with sealed lens ring
DC 12V standard, 24V optional; circuit protection function
Adjustable camera angle
Optional: non-heating switch board tail cable and single / dual / triple LED control

Points to confirm before production so the unit arrives ready to fit.

Confirm whether the shell size and fixing hole position match the bumper/trim of the vehicle model
Confirm the installation method: external mounting without drilling holes or drilling holes required
Confirm the signal type: CVBS, AHD 720P or AHD 1080P. An AHD camera must be paired with an AHD host.
Confirm the chipset — CVBS: 1058 / 4089 / 7430 / 7440 / 7080; AHD: 2053 / 528 / 536D / 536 / 4109.
Confirm lens angle. Around 108° horizontal is standard (110° nominal); 135° / 150° / 170° wide-angle versions are optional.
Confirm LED count and control method (always on, reverse-triggered or switch panel), and whether a low-heat switch-panel tail cable is required.
Confirm PAL or NTSC, whether parking guide lines are needed, and normal or mirrored image.
Confirm connector and voltage 12V / 24V, plus tail cable construction and length.
Confirm color, accessories (screws) and packaging, silk screen requirements

Voltage, wiring, sealing and maintenance guidance for the installer.

Before wiring, confirm the supply — DC 12V, or the 24V version on a 24V vehicle — and never reverse the red and black supply wires.
Before installing the plug-in, clean the fixing surface, tighten the screws and seal them well
The LED ring light panel is a thin plate structure. Do not squeeze or bump it during installation
Route the cable clear of hot surfaces and sharp sheet-metal edges, and do not pull the tail cable tight.
Seal the connector properly; bumper positions take a lot of water spray.
Clean the lens and LED board with a soft cloth — never alcohol or anything abrasive.
AHD cameras must be paired with an AHD host; CVBS and AHD cannot be mixed.

Car & Aftermarket Cameras