JPC-07LED small dome ring light car camera (small dome shell + ring LED fill light)

Key features

Small-cap shell with a full ring of LED lamps around the lens
The LED ring lights the whole area behind the car - the best night picture in the little dome family
Same compact shell as JPC-07, so it fits the same mounting holes and bumpers
Universal fitting for all cars; rear, front or side mounting
Signal options: CVBS 420/480 TV Lines, AHD 720P, AHD 1080P
Sensor options: HD CCD / CMOS; star-light night vision module (GC2053 / GC2083)
PAL or NTSC signal system; mirror image and reversing grid selectable
Waterproof IP69K; plastic housing with sealed lens ring
DC 12V & 24V; circuit protection function
Package: 1 x camera, 1 x 1 m DC power cable, 1 x 6 m AV cable, 1 x hole saw
Standard tail cable 5 copper + 5 steel; optional non-heating switch board tail cable and single / dual / triple LED control

Points to confirm before production so the unit arrives ready to fit.

Confirm the cut-out size (18.5 mm, 28 mm and others) matches the vehicle.
Confirm the signal type: CVBS, AHD 720P or AHD 1080P. An AHD camera must be paired with an AHD host.
Confirm the chipset — CVBS: 1058 / 4089 / 7430 / 7440 / 7080; AHD: 2053 / 528 / 536D / 536 / 4109.
Confirm lens angle. Around 108° horizontal is standard (110° nominal); 135° / 150° / 170° wide-angle versions are optional.
Confirm LED count and control method (always on, reverse-triggered or switch panel), and whether a low-heat switch-panel tail cable is required.
Confirm PAL or NTSC, whether parking guide lines are needed, and normal or mirrored image.
Confirm the connector (RCA, 4-pin aviation or BMW type) and voltage 12V / 24V.
Confirm the tail wire material and length
Confirm colour, accessories, packaging type and printing.

Voltage, wiring, sealing and maintenance guidance for the installer.

Before wiring, confirm the supply — DC 12V, or the 24V version on a 24V vehicle — and never reverse the red and black supply wires.
Confirm the hole diameter and panel thickness before cutting; on a push-in camera make sure the seal is compressed so no water gets in.
The LED ring light panel is a thin plate structure. Do not squeeze or bump it during installation
Route the cable clear of hot surfaces and sharp sheet-metal edges, and do not pull the tail cable tight.
Seal the connector properly; bumper positions take a lot of water spray.
Clean the lens and LED board with a soft cloth — never alcohol or anything abrasive.
AHD cameras must be paired with an AHD host; CVBS and AHD cannot be mixed.

Car & Aftermarket Cameras